How to Repair a Mercury Thermometer
Steps
![Repair a Mercury Thermometer Step 1.jpg]()
1Inspect the thermometer for damage. Do not use it anymore if it is cracked or damaged in any way. It has served its life and needs to be disposed of properly (see Warnings below).Ad![Repair a Mercury Thermometer Step 2.jpg]()
2Note the temperature indicated.- 3Choose a method for repairing the separated mercury.
Method 1 of 4: Cooling
This may be the easiest way to restore the column. However, do note that this method has varied results.
![Repair a Mercury Thermometer Step 3.jpg]()
1Place the thermometer in a refrigerator or ideally, a freezer. If cold enough, it should send the mercury (or other indicating fluid) to the bulb with little else to do. See the next steps if a refrigerator or freezer is not available or did not work.
Method 2 of 4: Warming
This method may take several attempts.
- 1Place the thermometer in the sink.
- 2Gradually heat the bulb with a hair dryer on warm. The mercury will rise to the top of the thermometer and join together.
- 3Allow the thermometer to gradually cool down to room temperature.
- 4If you need to take several attempts, just heat and cool gradually. Do not overheat, as the thermometer could burst.
Method 3 of 4: Shaking
This method is fairly reliable as it was often used in hospitals, etc. before the electronic thermometers and disposable temperature strips became commonplace. There is, however, a risk of losing grip of the thermometer while shaking that could result in breakage and spillage of mercury.
- 1Firmly grasp the thermometer near the top, so that the bulb containing the mercury (or other indicating fluid) is pointed downward.
- 2Rapidly move the the thermometer down and sharply reverse direction (and snap the wrist upward). When the thermometer reaches the lowest point of the stroke several times.
![Repair a Mercury Thermometer Step 4.jpg]()
3Recheck the indicated temperature. If the indicated temperature has been reduced from the last time checked, continue shaking the thermometer downward. It will likely require repeating many times before the void in the column has disappeared.
Method 4 of 4: Dropping
This method seems to have the best results, but also risks breakage of the thermometer if dropped from too high or on to a hard surface.
- 1Hold the thermometer vertically - with the bulb directed downward.
![Repair a Mercury Thermometer Step 5.jpg]()
2Drop the thermometer on a bed, pillow, or even a towel folded so that it is 8 (or more) times the non-folded thickness. Not more than a one or two foot drop is
